Home | advanc

Forgot Password

Lost your password? Please enter your email address. You will receive a link and will create a new password via email.

SHARE. LEARN. ADVANCE

Advanc is a platform where people in the oil and gas inspection industry can share their knowledge with the people who need it. Also, an excellent resource if you are preparing for the API certification exams, as you will find in the study guide a useful roadmap to guide you through your learning journey.

0

Tyler NewmanIncomer

Asked: June 16, 2021In: ASME

The stresses that cause fatigue cracking are typically:

0

Poll Results

100%Well below the yield strength of the material ( 1 voter )

0%Well above the notch toughness of the material

0%Well above the tensile strength of the material

0%Well above the yield strength of the material

Based On 1 Vote

Participate in Poll, Choose Your Answer.

0

Chris PowellIncomer

Asked: June 14, 2021In: Pressure Vessel Inspection

A cylindrical vessel shell has been found to have a minimum thickness of .353″. Its original thickness was .375″. Should this vessel continue to remain in service given the following variable? P= 300 psi, t = 0.353″, S= 13,800 psi, E= 0.85, R= 12.022, R0= 12.375″

0

0

youssoufoIncomer

Asked: December 19, 2020In: API

we have a pit with a depth of 7 mm , the nominal thickness of 15.875 mm and the required thickness of 11.5 mm . AS api 510 if we can ignored this pit or it must be repaired ?

0

0

Terrence McFaddenIncomer

Asked: November 12, 2020In: Pressure Vessel Inspection

The pressure in a vessel shall be gradually increased not more than one-half of the test pressure. Thereafter, the test pressure shall be increased in steps of approximately ______ of the test pressure until required test pressure has been reached.

0

Poll Results

No votes. Be the first one to vote.

Participate in Poll, Choose Your Answer.

0

JonIncomer

Asked: October 15, 2020In: General

What is considered to be the most dangerous work in the oil industry?

0

0

Anonymous

Asked: August 23, 2020In: Pressure Vessel Inspection

Which of the following relief devices is intended to work with steam boilers?

0

Poll Results

No votes. Be the first one to vote.

Participate in Poll, Choose Your Answer.

0

Abdullah MalikIncomer

Asked: July 28, 2020In: Piping Inspection

Piping system corrosion rates shall be calculated on?

0

Poll Results

0%Always on a short term basis

0%Preferably on a long term basis

0%On a circuit averaging basis

100%Either a short or long term basis ( 2 voters )

Based On 2 Votes

Participate in Poll, Choose Your Answer.

0

Richard BankoleIncomer

Asked: July 11, 2020In: General

What is the purpose of WPS and PQR combination?

0

0

RebeccaIncomer

Asked: July 5, 2020In: Pressure Vessel Inspection

What is the difference between thin and thick pressure vessel?

0

0

Chris PowellIncomer

Asked: June 17, 2020In: API

When is a pressure test normally required without being specifically requested by an API inspector?

0

Poll Results

0%After a repair

100%After an alteration ( 2 voters )

0%Following a failure

0%During a routine inspection

Based On 2 Votes

Participate in Poll, Choose Your Answer.